AGA-10 Angular Gripper - Double Guided, Low Profile

Design: Angular

Stroke: 0-180° Adjustable

Gripping Force @ 80 PSI [5.5 BAR]
Closing: 20 lbs [88 N]
Open: 22 lbs [97 N]

Time:
Close: 0.2 sec [0.2 sec]
Open: 0.2 sec [0.2 sec]

Pressure Range:
Low/High 10-120 PSI [.7-8 BAR]

Temperature Range:
Low/High -20°/180°F [-28°/80°C]

Side Play: ± 0.001 [.03 mm]

Repeatability from Center: ± 0.002 [.06 mm]

Loading Capacity: Static - Dynamic

Max Tensile T
22 lbs - 14 lbs
[100 N] - [65 N]

Max Compressive C
22 lbs - 14 lbs
[100 N] - [65 N]

Max Moment Mx
26 in/lb - 9 in/lb
[3 Nm] - [1 Nm]

Max Moment My
26 in/lb - 9 in/lb
[3 Nm] - [1 Nm]

Max Moment Mz
26 in/lb - 9 in/lb
[3 Nm] - [1 Nm]

Material: High Strength, Hard Coated
aluminum bronze alloys, Steel

Weight: 7 oz [198 g]

Piston Diameter: 0.787 in [20 mm]

• Grippers provide up to 180º of angular jaw travel allowing the jaws to completely retract from the work area eliminating another required axis of travel.
• High gripping force to weight ratio.
• Compact design with long, adjustable stroke.
• Jaw rotations can be adjusted from 0-90º to allow the gripper to be custom fit to each application.
• Units are permanently lubricated for non-lube air operation, allowing for compliance with OSHA regulation.
• Proximity sensors are available to monitor open and closed position of the jaws.
• AGA is fully field repairable for cost savings and minimum down time.
• The gripper body has two mounting surfaces with dowel pin holes to provide accurate mounting in a variety of positions.