|
Design: Parallel-Double Acting Synchronized Jaws
Stroke: 8-12 Inches
Gripping Force per Jaw @ 80psi: Closing = 1100 lbs.; Opening = 1120 lbs.
Time: Close = 0.5 sec.; Open = 0.5 sec.
Pressure Range: Low = 30 psi; High = 150 psi
Temperature Range: Low = -20 F; High = 180 F
Side Play: +/- 0.001"
Repeatability from Center: +/- 0.002"
Loading Capacity:
Max. tensile. T:
2500 lbs.
Max. Compressive C: 2500 lbs.
Max. Moment Mx:5000 in/lb
Max. Moment My:5000
in/lb
Max. Moment
Mz:5000
in/lb
Material: High strength, hard coated aluminum alloys and steel
Displacement: 55.00 cubic inch
Material: High strength, hard coated aluminum alloys and steel
Weight: 57 lbs.
Piston Diameter: 2x3 Inches
|
- Ultra high gripping force to weight ratio due to two
opposing independent pistons that direct power to the
jaws.
- True parallel jaw motion for easy tooling.
- Units are permanently lubricated for non-lube air operation,
allowing for OSHA compliance.
- Piston seals are u-cup type for long service life.
- Four large jaw support shafts are guided through the
width of the main body
- Proximity switches are available to monitor open and
closed position of the jaws.
- Series AGW-3000 is fully field repairable for cost
savings and minimum down time.
- Non-synchronous versions allows the gripper's jaws
to comply to the part's centerline verses the gripper's
centerline.
- Strokes range from 8 - 12 inches to fit your application.
- Totally sealed unit repels contaminants.
|
