AGW-375-1 Wide Body Series Parallel Gripper

PRODUCT SPECIFICATIONS

FEATURES AND BENEFITS

Design: Parallel, Double Acting, Synchronized Jaws

Stroke: 1 in [25.4 mm]

Gripping Force @ 80 PSI Per Jaw [5.5 BAR]
Closing: 36 lbs [160 N]
Opening: 38 lbs [170 N]

Time:
Close: 0.3 sec [0.3 sec]
Open: 0.3 sec [0.3 sec]

Pressure Range:
Low/High 20-120 PSI [1.7-8 BAR]

Temperature Range:
Low/High -20°/180°F [-28°/80°C]

Side Play:
± 0.001 [.03 mm]

Repeatability from Center:
± 0.002 [.06 mm]

Loading Capacity: Static - Dynamic

Max Tensile T
100 lbs 20 lbs
[445 N] [89 N]

Max Compressive C
100 lbs 20 lbs
[445 N] [89 N]

Max Moment Mx
175 in/lb 35 in/lb
[18.7 Nm] [4 Nm]

Max Moment My
250 in/lb 50 in/lb
[28 Nm] [5.6Nm]

Max Moment Mz
175 in/lb 35 in/lb
[19.7 Nm] [4 Nm]

Material: High Strength,Hard Coated aluminum bronze alloys, Steel

Weight: 1.3 lbs [6 kg]

Piston Diameter: .625 in x 4 [15.8 mm]

• Ultra high gripping force to weight ratio due to four opposing independent pistons that direct power to the jaws.
  
  
•  True parallel jaw motion for easy tooling.
  
  
•  Units are permanently lubricated for non-lube air operation, allowing for OSHA compliance.
  
  
•  Piston seals are quad-ring type for long service life.
  
  
•  Large jaw support shafts are guided through the full width of the main body.
  
  
•  Proximity switches are available to monitor open and closed position of the jaws.
  
  
•  Series AGW-375-1 is fully field repairable for cost savings and minimum down time.
  
  
•  Non-synchronous versions allow the gripper's jaws to comply to the part's centerline versus the gripper's centerline.