AGW-375-4 Wide Body Series Parallel Gripper

PRODUCT SPECIFICATIONS

FEATURES AND BENEFITS

Design: Parallel-Double Acting Synchronized Jaws

Stroke: 4"

Gripping Force per Jaw @ 80psi: Closing = 36 lbs.; Opening = 38 lbs.

Time: Close = 0.6 sec.; Open = 0.6 sec.

Air Consumption: 490 cubic inches/min

Pressure Range: Low = 30 psi; High = 150 psi

Temperature Range: Low = -20 F; High = 180 F

Side Play: +/- 0.001"

Repeatability from Center: +/- 0.002"

Displacement: 2.46 cubic inch

Material: High strength, hard coated aluminum alloys and steel

Weight: 3.2 lbs

Piston Diameter: .625 in. x 4

• Ultra high gripping force to weight ratio due to four opposing independent pistons that direct power to the jaws.
  
  
• True parallel jaw motion for easy tooling.
  
  
• Units are permanently lubricated for non-lube air operation, allowing for OSHA compliance.
  
  
• Piston seals are quad-ring type for long service life.
  
  
• Large jaw support shafts are guided through the full width of the main body.
  
  
• Proximity switches are available to monitor open and closed position of the jaws.
  
  
• Series AGW-375-4 is fully field repairable for cost savings and minimum down time.
  
  
• Non-synchronous versions allow the gripper's jaws to comply to the part's centerline versus the gripper's centerline.