AGW-500-1 Wide Body Series Parallel Gripper

PRODUCT SPECIFICATIONS

FEATURES AND BENEFITS

Design: Parallel-Double Acting Synchronized Jaws

Stroke: 1.500"

Gripping Force per Jaw @ 80psi: Closing = 84 lbs.; Opening = 86 lbs.

Time: Close = 0.3 sec.; Open = 0.3 sec.

Air Consumption: 361 cubic inches/min

Pressure Range: Low = 30 psi; High = 150 psi

Temperature Range: Low = -20 F; High = 180 F

Side Play: +/- 0.001"

Repeatability from Center: +/- 0.002"

Displacement: 1.80 cubic inch

Material: High strength, hard coated aluminum alloys and steel

Weight: 3 lbs

Piston Diameter: 0.875" X 4

• Ultra high gripping force to weight ratio due to four opposing independent pistons that direct power to the jaws.
  
  
•  True parallel jaw motion for easy tooling.
  
  
•  Units are permanently lubricated for non-lube air operation, allowing for OSHA compliance.
  
  
•  Piston seals are quad-ring type for long service life.
  
  
•  Large jaw support shafts are guided through the full width of the main body.
  
  
•  Proximity switches are available to monitor open and closed position of the jaws.
  
  
•  Series AGW-500-1 is fully field repairable for cost savings and minimum down time.
  
  
•  Non-synchronous versions allow the gripper's jaws to comply to the part's centerline versus the gripper's centerline.