AGW-625-6 Wide Body, Synchronous / Non-Synchronous
Series Parallel Gripper

PRODUCT SPECIFICATIONS

FEATURES AND BENEFITS

Design: Parallel, Double Acting, Synchronized Jaws

Stroke: 6 in [152.4 mm]

Gripping Force @ 80 PSI Per Jaw [5.5 BAR]
Closing: 130 lbs [578 N]
Opening: 132 lbs [587 N]

Time:
Close: 0.3 sec [0.3 sec]
Open: 0.3 sec [0.3 sec]

Pressure Range:
Low/High 20-120 PSI [1.7-8 BAR]

Temperature Range:
Low/High -20°/180°F [-28°/80°C]

Side Play:
± 0.001 [.03 mm]

Repeatability from Center:
± 0.002 [.06 mm]

Loading Capacity: Static - Dynamic

Max Tensile T
1300 lbs 150 lbs
[5700 N] [667 N]

Max Compressive C
1300 lbs 150 lbs
[5700 N] [667 N]

Max Moment Mx
1100 in/lb 120 in/lb
[124 Nm] [13.5 Nm]

Max Moment My
1500 in/lb 130 in/lb
[170 Nm] [14.7Nm]

Max Moment Mz
1100 in/lb 120 in/lb
[124 Nm] [13.5 Nm]

Material: High Strength,Hard Coated aluminum bronze alloys, Steel

Weight: 9.7 lbs [4.4 kg]

Piston Diameter: 1.625 in [41.3 mm]

• Ultra high gripping force to weight ratio due to four opposing independent pistons that direct power to the jaws.
  
• True parallel jaw motion for easy tooling.
  
• Units are permanently lubricated for non-lube air operation, allowing for compliance with OSHA regulations.
  
• Piston seals are quad ring type for long
  service life.
  
• Large jaw support shafts are guided through the full width of the main body.
  
• Proximity switches are available to monitor open and closed position of the jaws.
  
• The AGW Series is fully field repairable for cost savings and minimum down time.
  
• Non-synchronous versions allow the gripper’s jaws to comply to the part’s centerline versus the gripper’s centerline.