AGR-2 Rotary Actuator

PRODUCT SPECIFICATIONS

FEATURES AND BENEFITS

Design: Rack and pinion with flange hard stop

Rotation Range: 0 to 180 degrees (Adjustable +/- 5 degrees)

Payload: 3 lbs central to axis of rotation

Torque @ 80 psi: 17 lbs*in

Bearing Load: Dynamic = 385 lbs.; Static = 198 lbs.

Rotation Time: No-Load = 0.1 sec

Air Consumption: 432 cu in/min

Pressure Range: Low = 30 psi; High = 120 psi

Temperature Range: Low = -20 F; High = 180 F

Backlash: zero

Accuracy: 0.001 concentric and perpendicular to axis of rotation

Displacement: 0.72 cu in

Material: High strength, hard coated aluminum alloys and steel

Weight: 1.2 oz

Piston Diameter: 0.75 in

• Built-in adjustable hardstops on output flange stop against a dowel pin embedded in the body to prevent pinion breakage and give accurate specific rotation requirements.
  
  
•  Two large bearings, one on either side of the pinion, provide for steady output flange with high loading capacity.
  
  
•  Ultra high torque-to-weight ratio for faster cycle times.
  
  
•  Compact body design to fit in tight space applications.
  
  
•  Units are permanently lubricated for non-lube air operation, allowing for compliance with OSHA regulations.
  
  
•  All rotary units have zero backlash at either end of rotation, keeping the output flange against the hardstop.
  
  
•  Built-in adjustable flow controls allow for maximum cycle times and smooth deceleration.
  
  
•  Proximity switches are available to monitor end of rotation.
  
  
•  The AGR-2 unit is fully field repairable for cost savings and minimum down time.