AGW-500-4 Wide Body Series Parallel Gripper

Inch & Metric DWG 2D	PRODUCT PORTFOLIO	Inch Solid Works, 3D IGES, Step	Metric Solid Works, 3D, IGES & Step	PDF
DWG	AGW-500-4	3D	3D	AGW-500-4

PRODUCT SPECIFICATIONS

FEATURES AND BENEFITS

Design: Parallel, Double Acting, Synchronized Jaws

Stroke: 4 in [101.6 mm]

Gripping Force @ 80 PSI Per Jaw [5.5 BAR]
Closing: 84 lbs [373 N]
Opening: 86 lbs [383 N]

Time:
Close: 0.5 sec [0.5 sec]
Open: 0.5 sec [0.5 sec]

Pressure Range:
Low/High 20-120 PSI [1.7-8 BAR]

Temperature Range:
Low/High -20°/180°F [-28°/80°C]

Side Play:
± 0.001 [.03 mm]

Repeatability from Center:
± 0.002 [.06 mm]

Loading Capacity: Static - Dynamic

Max Tensile T
500 lbs 50 lbs
[2220 N] [222 N]

Max Compressive C
500 lbs 50 lbs
[2220 N] [222 N]

Max Moment Mx
500 in/lb 50 in/lb
[56.5 Nm] [5.6 Nm]

Max Moment My
750 in/lb 75 in/lb
[85 Nm] [8.5Nm]

Max Moment Mz
500 in/lb 50 in/lb
[56.5 Nm] [5.6 Nm]

Material: High Strength,Hard Coated aluminum bronze alloys, Steel

Weight: 6 lbs [2.7 kg]

Piston Diameter: .875 in x 4 [22.3 mm]

Ultra high gripping force to weight ratio due to four opposing independent pistons that direct power to the jaws.
True parallel jaw motion for easy tooling.
Units are permanently lubricated for non-lube air operation, allowing for compliance with OSHA regulations.
Piston seals are quad ring type for long
service life.
Large jaw support shafts are guided through the full width of the main body.
Proximity switches are available to monitor open and closed position of the jaws.
The AGW Series is fully field repairable for cost savings and minimum down time.
Non-synchronous versions allow the gripper’s jaws to comply to the part’s centerline versus the gripper’s centerline.